Power Supply¶
Before using the device for the first time, connect it to the power supply.
Ensure the power supply is disconnected before connecting the device.
The main plug connector supplies the device with power. If you use the power supply unit from the kit, make sure you use the country adapter for your country.
Correct wiring and configuration of the power management settings is mandatory to protect the device from damage and data loss.
The main purpose of the power management settings is that the device has a safe shutdown before the supply voltage (terminal 30/31) is disconnected.
Warning
Overload damage due to malfunction.
Risk of severe or fatal injury.
- To limit power in the event of malfunction, secure the DC power supply circuit during installation with an external 2 A fuse.
Note
Device defect due to power failure.
Destroyed hardware component on the device. Repair not possible.
Destroyed file system on the device. Repair by Proemion necessary.
- Permanently connect terminal 30 to steady power supply (vehicle battery) to ensure that the required power management settings can be applied to the device in the right manner.
- Permanent disconnection from the power supply is only permitted when the device was set to sleep mode before.
- Connect terminal 15 correctly and configure secure switching to sleep mode in the Power Management section of the device configuration.
- Do not disconnect the device from the power supply until it has completely switched to sleep mode (all LEDs off).
If anything is unclear, contact our support. See Service and Support.