Connectors¶
The Display 1001 is equipped with the following connector:
The 5-pin male power/CAN connector is used to supply the Display 1001 with a voltage of 9V to 60V and to connect it to a CAN bus.
The drawing below shows an overview of the explained hardware component:
Power/CAN Connector¶
Apart from connecting Display to the power supply, the two power/CAN connectors connect your display to the CAN bus. The pin assignment of the power/CAN connector is shown in the table and drawing below.
| Function | Pin |
|---|---|
| Ground | 1 |
| VCC (9 V – 60 V) | 2 |
| CAN GND (internally connected to Ground !) | 3 |
| CAN H | 4 |
| CAN L | 5 |
